The Roadmaster 68-inch Single Hook Safety Cables # RM-643, will work out great for use with your Roadmaster Falcon tow bar and Blue Ox Base plates. However, you will need to use the adapter bar specified for using Roadmaster tow bars with Blue Ox base plates; the Roadmaster Tow Bar Adapter # RM-031.
The Roadmaster safety cables # RM-643 will work wonderfully with the Roadmaster built-in cable guide on the Falcon tow bar.
The safety cables that you mentioned above, the Roadmaster EZ Hook... view full answer...
The trailer wiring adapters are not vehicle specific. They are universal and will be matched by what type of connector is on the tow vehicle and what type of connector is on the trailer.
The Hopkins Adapter 7-Way Round Pin To 4-Way Flat, part # 47405, is for a vehicle that has a 7-Way round pin connector and you are connecting to a trailer with a 4-Way flat connector.
The 7-Way blade style connectors are more common than the 7-Way round pin connectors. I would check the 7-Way connector... view full answer...
The Firestone Coil-Rite Air Helper Springs, # F4121, will work on your 2000 Land Rover Discovery. These air springs will not replace any part of your suspension, instead, they fit inside of your existing coil springs to help level your vehicle, improve braking and handling and reduce tire wear. You will not need to buy any additional parts to install this kit.
I have attached the installation instructions for you to check out.
If you were interested in a compressor kit for these air... view full answer...
For a spare tire bike rack on your 2002 Land Rover Discovery II we offer the Yakima SpareRide 2 Bike Carrier, item # Y02599, that should work on your vehicle also as long as you do not have a significantly over-sized spare. It will fit a spare tire width from P195 (7.7 inches) to P318 (12.5 inches).
You may also need to use a bike adapter bar like the Yakima Tube Top Bike Adapter Bar, item # Y02531, for alternative frame bicycles. view full answer...
There is a trailer hitch that fits your 2000 Land Rover Discovery II, but not the one you referred to. Instead you will need the Curt # 13455 which is a 2" hitch that is a bolt-on installation so no drilling into your Discovery's frame will be necessary.
For wiring which will give you a 4-way connector and allow you to power your trailer's lights you need Wiring Harness # 119178KIT. I also recommend checking out Ball Mount Kit # 989900, which is for 2” hitches and may fulfill your towing... view full answer...
It is entirely possible that the bike carrier you have was made by Thule. A Coworker found out that Thule made the bike racks for Land Rover until 2000 and then they switched to Yakima.
Does the carrier have a name on it or a number of any kind? I could likely verify the manufacturer with a name or a part number or even by looking at some pictures of the carrier which you are welcome to email to me.
If it is indeed a carrier manufactured by Thule then the Snug Tite lock # THSTL2 would fit. view full answer...
The Tekonsha Prodigy RF Brake Controller, # TK94FR, will work on your 2004 Land Rover Discovery II. However, you will need to have a 4-pole flat and a 7-way trailer connector installed on the vehicle for this brake controller to work.
If you do not have a 4-pole flat, then I recommend the Tekonsha Tail Light Convertor # 119178KIT. This kit will allow you to install the 4-pole flat plug needed to run the trailer turn, tail, and stop lights off of your vehicle's electrical system.
You will... view full answer...
The Weathertech cargo mat part # WT41162 that fits your 2003 Land Rover Discovery II fits from behind the second row of seats back. view full answer...
The Reese Titan Weight Distribution Shank, part # RP54977, will fit the Reese hitch head in the Reese weight distribution kit, part # RP66074. You will want to make sure that the 5-3/4 inch drop or 8-1/4 inch rise on the Reese Titan # RP54976 shank will work properly for the setup on your 2011 Ford Super Duty.
To make an approximate determination of the rise or drop that is needed for your weight distribution shank, first jack up your trailer so that it is level and measure from the bottom... view full answer...
I contacted our representative at Roadmaster and he informed me that the Roadmaster XL Base Plate Kit, part # 1910-1 will work with your dealer installed brush guard.
To complete your flat-towing setup, you will need a tow bar, safety cables, wiring or lighting, and a supplemental brake system.
The Roadmaster Falcon All Terrain Tow Bar, part # RM-522, would be a good option for a tow bar as it is a non-binding tow bar. The non-binding feature makes for easier hookup and disconnecting... view full answer...
The Wheel Masters Vision Plus Extendable Towing Mirrors part # WM6500 has not been fit tested on the 2003 Land Rover Discovery II. However, I spoke to my contact at Wheel Masters who said you can test this yourself by checking under the edge of the bottom of your vehicle's door. If the door's bottom edge is more than 1-1/2 inches wide, the mirrors will not fit because it will be too wide for the clips to strap onto. If the edge is less than 1-1/2 you have a fit.
If they don't work you... view full answer...
Go To Results